Hello everyone! Today, I have a card to share with you. It features a banner, arrow, bicycle and a felt flower... all of my favorite little things! So, let's get started. The card base is the Sizzix Scoreboards XL Die - Frame, Mailable
...yes, it is a frame but, I thought it would make a great card too (and it did)!
from a 6 X 11 sheet of kraft cardstock, aligning the edge of paper just above the cutting line (straight edge) of frame... in other words, you will not get the whole length of the frame, some of the pointed end will not cut do to the length of the paper. Now, die cut two lower ends of the frame from patterned paper. Die cut
them just above the score line and then trim them to fit the flap. Machine stitch around the flaps. Now, I will be referring to the frame as a card.
Fold the card along the scored lines, machine stitch along the edge of cardstock as shown in the photo below. Adhere the two flaps together (wrong sides together). Adhere the flap to the inside of the card as shown in picture above.
Using the Framelits Die Set - Bicycle
, stamp the medium sized bicycle onto patterned paper, then place the coordinating bicycle framelit on top of the stamped image and die cut
Using the same technique, die cut three banners and the large arrow from patterned paper. Machine stitch along the left side of arrow. Cut a piece of patterned paper to fit inside the card, machine stitch. Using the Flower Rings and Clusters Embossing Folders
, emboss the square patterned paper piece only, adhere to the inside of card.
Adhere a piece of lace about an inch up from the bottom of paper (shut the card to make sure the lace is aligned the way you want it to be). Using some Pop Dots, adhere the bicycle in the center of lace again, you might want to shut the card then adhere it so that you get it centered correctly. Adhere buttons in the center of the wheels.
Wrap a piece of seam binding or ribbon around the front of card and adhere, tie a bow and adhere to the top left corner, adhere heart and button in center of bow. Machine stitch (or just adhere) together the three banner pieces leaving a few inches of thread at each end for tying, adhere the word sticker (sister) in the middle banner. Stamp the "Paris" image in the top right corner of card.
Stamp the sentiment in the arrow, adhere the arrow at the bottom of the card. Using the Flowers, 3-D
die, cut from felt the smaller flower. I only rolled the flower about three or four times and then cut the excess because I wanted the flower to be smaller to fit into the arrow. Adhere a pearl into the center of flower.
Flip the card to the back and adhere a button at the end of the flap... all done!
Thank you for stopping by today...
Paper: Kraft Cardstock; patterned paper
Stamps: Tim Holtz Holtz Stampers Anonymous- CMS087 SHABBY FRENCH
Ink: Ranger Archival Ink Pad - Coffee
Stickers: Tim Holtz Idea-ology- Chit Chat Stickers
Adhesive: Circle Pop Up Dots
Misc.: ribbon; buttons